Handmade picture framing detailed steps

Detailed steps for handmade picture framing are as follows

First step

Preparation of batter. Batter homemade process more, remove the gluten is so troublesome. You can buy it in bottles at the stationery store. When used to get the required amount of paste with cold water to dilute, not too thick, not too thin, can flow can.

Step 2

Brush. Lay the piece flat on a smooth board or glass countertop (front side down, back side up); use a wool brush to spread the diluted paste evenly over the back of the piece, not too much.

Take a piece of rice paper that is about 2 centimeters wider than the work all around, roll a long tube and slowly put the rice paper from one side with your left hand, take a brush with your right hand (a dry brush) and brush back and forth left and right and slowly put the rice paper and continue to brush until the rice paper is brushed. Brush can be covered with a layer of newspaper to continue to brush, painting heart solid, specific requirements can not be loose to leave bubbles.

Then use a paste brush around the edge of the work 2CM brush on the paste (the middle of the brush, do not brush, is to ensure that the work can be easily uncovered after drying); finally pick up the framed work, the front of the work towards themselves, affixed to the wall or the glass of the floor door, with a dry brush in the work of the vertical brush a brush, horizontal brush a brush, painting the meter can be,

Finally, the last work around the 2cm Brush outwards. This way the work is pasted on the wall or on the glass of the floor door and left to dry.

Step 3

Pick. After two or three days, when the piece is dry pull it off slowly by hand from corner to corner. Don't wrinkle it!

Step 4

Cut. After the work is taken down from the wall, then cut the edges of the shaped work; then set the ditch strips around the reverse side of the shaped work with thick paste, and the front side should be exposed to the edge of the ditch strips by 5mm (the color is good for dark color).

The fifth step

Inlays, that is, the periphery of the work of decoration (color you like). Cutting inlay: first cut the long side of the work x 5.5CM two pieces, in the long side of the brush on the 0.5CM wide paste paste on each side of the work: and then to its upper head width x length (the work of the length of the 2 plus 3CM); below the width x length (the work of the length of the 3 plus 10CM) under the cut inlay paste. To dry.

Step 6

Cutting the inlay. Cut the length of the finished product (item 5) +20cm, width +5cm and leave it on the roll. Stick the roll. (Item 5) dry finished product in accordance with the method (Item 2), brush the paste, and then (Item 6) the top of the top of the work aligned with the top of the roll of paper pasted on the work. Uncover again and stick it on the wall and leave it to dry naturally.

Cutting the edges. In two or three days remove the dried (item 7) and cut the corners flush. The last step is: install the rod, on the tape, can be completed!