lnglesina baby stroller installation instructions

Baby stroller is a necessity for every little baby, many baby moms will not press the installation themselves, the following look at our editor is how to help our neighbors to install the baby stroller.

First: Prepare two screwdrivers, one Phillips and one flat. Then open the bracket and prop it up first.

Second:According to the observation, it is easier to install the item basket under the bracket first, there are two buckles on each side of the item basket, which are fastened to the main shelf next to it.

Third: the backrest and cushion mounted, the first set of backrest, directly along the backrest set down, cushion on both sides of the sticky strips, directly on both sides of the armrests.

Fourth: to the car pressed on the four wheels, open the brake, along the bottom of the bracket, wear in, hear a click, indicating that the wheel as well as the installation of good.

The last step, the installation of the awning, directly along the handrail on both sides of the extra two halves of the steel pipe set down, hear the sound can be, that has been installed in place.

Parts CompositionBefore using the pouch P37 stroller, please make sure you have the following parts, if you are missing a part, please contact our customer service department. Components: front wheels, rear wheels, front armrests, cups, body, canopy

Open the stroller

Take hold of the handlebar in each hand and pull up the A unlock button, the same as lifting up the car platform, then the whole stroller will unfold until you hear a "pop" sound, indicating that the upper and lower joints of the frame have been locked and unfolded in place.

Front wheel assembly and disassembly

Installation: lift the front foot of the cart with one hand, and insert the front wheel shaft into the seat hole of the front wheel with the other hand until you hear a "pop" sound, indicating that the installation is in place.

Disassembly: One hand presses the quick release iron piece in the circle behind the front wheel seat, and the other hand pulls out the front wheel downward at the same time.

Rear wheel assembly and disassembly

Change to "Installation": lift the rear foot of the cart with one hand, and insert the rear wheel axle into the hole of the rear wheel seat with the other hand, and when you hear a "pop" sound, it means the installation is in place.

Disassembly: Lift up the rear wheel, press the disassembly button in the circle under the rear wheel base with one hand, and pull out the rear wheel with the other hand.

Note: Please try to pull both sides to make sure it is firmly installed.

Installation and removal of front armrest

Installation: Insert the plugs of the front armrest into the plastic holes on the root and lower body, and when you hear a "pop" sound, it means that the two sides are installed in place (you can check whether it is in place by lifting it upwards after installation).

Disassembly: Press the disassembly button in the circle shown in the illustration with one hand, and lift up the armrest with the other hand at the same time to remove it.

Drinking cup installation and removal

Installation: Insert the slot on the drinking cup by aligning it with the hook on the right side of the handle tube as shown in the illustration.

Removal: Hold the cup and pull it out.

Installation and disassembly of the canopy

Installation: Insert the sockets on both sides of the canopy into the corresponding positions on both sides of the tube on the corresponding seat, and when you hear a "click" sound, the button will pop up, that is, it will be installed in place.

Disassembly: First, close the canopy backward, then press the button in the circle (as shown in the picture) with both hands respectively, that is to say, the canopy can be disassembled.