How to mount rubbings with white characters on black background?

Before mounting the rubbings, carefully observe the rubbings before implementing the scheme. Because when it is spread out, the paper is brushed in the words and patterns, and the paper inside has been stretched. When it is spread out, although the rice paper shrinks, the part that stretches the ears will never recover as before.

Especially the new rubbings should be folded and wrapped in paper before mounting. Don't press them too tightly, lest they stick. Steaming in a steamer for 20-30 minutes, so that the ink glue can be firmly fixed on the rubbings and will not be deinked due to moisture during mounting.

The specific mounting method is to spread the rubbings to be supported on the table in reverse. When sizing, you can't use big combination pens, only two or three small combination pens or a big brush. Immerse the wool loop in the mud. When brushing paste, you must brush it slowly with a pen according to the structure of rubbings or words. Where the rubbings are wrinkled, let them be wrinkled. The wet point on the slurry has little to do with it. After covering the supporting paper, gently sweep it with a feather broom and wait for a while. Lay the absorbent paper beside it, lift the rubbings with a good paper holder, put them on the laid absorbent paper, and brush them with a brown brush.

It absorbs water. Then brush thick paste on the four sides of the supporting rubbings, and stick a small piece of paper at the bottom for lighting and climbing the wall. After drying for a few days, take it off and cut it neatly. The margins should be wide enough for engraving on the book.

When mounting the rubbings of three-dimensional figures, the method is the same as that of mounting the whole rubbings mentioned above, except that the full text of the bronze inscription should be attached to a certain position on the top of the three-dimensional figures, which should conform to the rules. Only in this way can it become a complete three-dimensional graphic rubbings. After being installed on the shaft, it can be appreciated or treasured as a work of art.

(2) Installation of album pages

This method requires that the number of words and lines of rubbings must be consistent with the original stone carving order, and the skipped spaces and broken words should not be cut off, but should also be cut off and mounted as much as possible. There are several lines on each page, and the position of the head, year and month, signature, and small postscript with title at the beginning and end should be well drawn; Words must be coherent before they can be cut into strips and then mounted into strips. Mounted album pages are often inlaid with ribbed paper, which is clean and quaint. Writing can be made of woven cotton or silk, or nanmu or mahogany.

The rubbings of rubbings or only a layer of tissue paper is padded, and each layer of seams is bonded with paper and rolled circularly, which is called folding and mounting.

If the word is large, it can be one word per page or two words per page, which is more expensive. Silk falls off easily and the paper quality is better.

The rubbings of rubbings can also be mounted in the form of books, and the lines are threaded into books. Although this book is good-looking, it also has its shortcomings. It is easy to degum for many years and make a push-up album. If you want to wrap it all around, you must not wear a piece of paper on each page to make the thickness uniform. It's just that the clip is particularly easy to disperse.