How to make the simplest kite?

The easiest way to fly a kite is as follows:

1, first make 2 pieces of wood, 60 cm 1 piece, 50 cm piece.

2. Draw a line in the middle of the 50 cm block and carve a small hole to facilitate the back fixation.

3. Cut both ends of these two pieces of wood. Colour it in your favorite color.

4. To make a fringed tail, use a ruler and a craft knife, and a piece of paper about 3 cm wide and 20 cm long will do.

5. Roll it up with a rice stick, wrap it, and then wrap it with tape. After tying, take out the stick (keep the hole where the stick is pulled out) and repeat the two tails.

6. Grab a mark at 15 cm with a 60 cm block and make a fixed point. Tie it where it is marked. X-tie method.

7. Use two adhesive rings around the two sticks (as shown in the figure). Tie it up and cut off the extra thread.

8. Find a piece of paper big enough (you can spell one if it is not enough). It is best to make the paper stronger. Then draw a schematic line on the edge of the line with a pencil, and then draw a folding line with a width of about 3 cm.

9. The lines at the four corners are according to the picture. Fold the excess paper according to the side rope. Then stick it with tape.

10. Finally, seal the joint with adhesive tape. Thread the thread through the place where the tassel passed just now, and you can thread it several times until you make sure that the tassel is fastened. Leave a line about 20 cm on your head.

1 1, and the other two tails are knotted. Tie the tassel tail to the bottom of the kite. Tie a double knot and make sure it is. Punch holes. The first hole is along the 60 cm bottom of the kite at 15 cm. The second hole is under the intersection of two pieces of wood. Carve a hole with a knife.

12, connect the two lines together and tie a slipknot, so that the angle of the kite can be adjusted. That's all.