How to connect the remote intelligent switch? Attached. Be specific, thank you.

1. Two black wires are connected in parallel inside the remote control switch. Pick a zero line (the black line on the side is connected to the zero line in the picture).

2. Another black wire and blue wire near the other side of the shell are connected to both ends of the load respectively.

3. The red wire is connected to the switch on the wall, and then connected to the live wire.

Extended data

Remote control switch positioning code

First, set the code.

1. Press and hold the touch button of the receiver for 5 seconds, and enter the learning state after hearing the beep and hold it for 15 seconds. Press the button of the transmitter, and the red indicator will light up 1 sec to transmit. Hearing the beep of the receiver indicates success in learning.

2. Detailed functional explanation: "Code matching" is a process in which the receiver learns the address code and control code of the sender. Through "code matching", the relationship between master and controlled is established.

3. First, it is expected to select the receiver and transmitter, and press and hold the switch button of the receiver for 5 seconds (when pressed, the light will be turned on or off, and the force will exceed 75g). When you hear a buzzer, it means that you have entered the learning state and will keep learning state 15 seconds.

4. Press the transmitter button, and the red indicator lights up. At this point, when you hear the "beep" sound again at the receiver, it means that you have learned successfully. Then press the transmitter button again, and the light at the receiver will be remotely controlled.

Second, delete the code.

1. For the address code that has been learned, it will be deleted if you learn it again.

2. Delete function is used to change the wrong setting, which is a common and important function and one of the important features of this switch.

Baidu Encyclopedia: Remote Control Switch Check Code