How to frame a painting on rice paper?

The specific steps for framing paintings:

1. Batter homemade process, remove the gluten is so troublesome. Stationery stores sell bottled. When used to get the amount of paste needed to dilute with cold water, not too thick, not too thin, can flow.

2. Lay the work on a smooth board or glass table (front side down, back side up); ★ Use a wool brush to dilute the paste evenly on the back of the work, do not paint too much. Take a piece of rice paper that is about 2 cm wider than the work all around, roll a long tube left hand from one side and slowly put the rice paper, the right hand to take a brush (to dry brush) back and forth and slowly put the rice paper and continue to brush until the rice paper brush finished. Brush can be covered with a layer of newspaper to continue to brush, painting heart solid, specific requirements can not be loose to leave bubbles. ★ and then use the paste of the brush around the edge of the work 2CM brush on the paste (the middle of the brush, do not brush, is to ensure that the work can be easily uncovered after drying); ★ and finally pick up the framed works, the front of the work towards themselves, affixed to the wall or the floor of the door of the glass, with the dry brush in the work of vertical brush a brush, horizontal brush a brush, painting the meter can be, and finally the works around the 2cm to the outside brush. ★ So that the work is pasted on the wall or landing door on the glass, to dry.

3. Two or three days later, when the work is dry with the hand from corner to side to pull it off slowly. Don't wrinkle it!

4. After the work is taken down from the wall, then cut the edges of the stereotypes; then in the stereotypes of the work of the reverse side of the surroundings with thick paste set on the channel strips, the front side of the channel strips should be exposed to the edge of the 5MM (the color of the dark color is good).

5. Then inlays: that is, the periphery of the work of decoration (color set your favorite). Cutting inlay: first cut the long side of the work × 5.5CM two pieces, in the long side of the brush on the 0.5CM wide paste paste works on each side: and then to the top of the head of the width × length (works of the length of 2 \ 5 plus 3CM); below the width × length (works of the length of 3 \ 5 plus 10CM) under the cutting of the inlay paste. To dry.

6. cut 5 finished length +20cm, width +5CM A Xuan paper rolls to be used.

7. ●5 items ● dry finished product in accordance with the ●2 items ● method to brush the paste, and then ●6 items ● the top of the work of the top of the alignment of the roll of paper pasted on the work. Then lift it up and stick it on the wall and leave it to dry naturally.

8. Two or three days will be dry ● 7 items ● remove, cut the corners.

9. The last step is to mount the pole and tape.