A complete manual course of chopsticks making.

The manual chopsticks tutorial is as follows:

First of all, the waterwheel

Materials required: scissors, glue gun, disposable bamboo chopsticks 10-20.

1. Cut some bamboo chopsticks into 2 cm long pieces with scissors.

2. Make the blades of the waterwheel

3, every 5 paragraphs as a group, stick together. Take two more bamboo chopsticks and cut them at 5.5 cm. Six blades were manufactured in this way.

4. Make scissors for the axle of the waterwheel. Give 6 4 cm long bamboo chopsticks, 1 7 cm long bamboo chopsticks. Six roots are combined around the center.

5. Assemble the waterwheel and stick the blades on the central shaft. Pay attention to symmetry and parallelism when pasting.

6. Make and assemble the water wheel bracket, assume the remaining chopsticks as brackets, and put the water wheel in the triangle on the third floor, and a lifelike mini water wheel will be ready.

Second, the bucket:

Required materials: empty chewing gum bottle, clean disposable chopsticks, double-sided adhesive tape, hemp rope or brown thick cotton thread.

1. Cover the empty chewing gum bottle with a utility knife and smooth the gap with a file or sandpaper;

2. Wrap two circles of double-sided tape around the decapitated chewing gum bottle, and then stick it vertically on the bottle with disposable chopsticks cut into small pieces, as shown in the figure. Note that a pair of chopsticks is 5-7 cm higher than other chopsticks on the opposite side of 180 degrees;

3. Wrap twine or cotton thread around chopsticks twice and tie a knot.

Third, the mobile phone bracket

Material: old chopsticks, rope or gauze.

1, prepare some chopsticks and rubber bands first;

2. Then tie three chopsticks together with a rubber band;

3. Then tie a chopstick horizontally on any two tripods;

4. Finally, tie them with chopsticks to increase the width;

5. Put the mobile phone on it, and a mobile phone bracket made of old chopsticks will be ready.