Installation method of ceramic tile and floor sealing strip

Tiles and floor sealing strips are installed between the tiles and the floor to beautify the ground. The following describes the installation method of tile and floor edge banding.

Material preparation: ceramic tile and floor edge banding, floor tile, glue, saw, ruler, sweeper, etc.

Installation steps: 1. Measure the distance between the tile and the ground, then cut the sealing strip with a saw, put the cut sealing strip in the reserved position, and confirm whether the length of the sealing strip and the floor tile is appropriate. 2. Spread the glue evenly on the ceramic tile, then put the ceramic tile in the reserved position, compact it hard and pat it flat. 3. Place the floor sealing strip in the reserved position according to the length sequence. 4. Apply the glue evenly on the floor sealing strip, and the coated area should not be too thick, so as not to affect the appearance. 5. Place the floor sealing strip in the reserved position and press it hard until the glue is fixed and dry (the time is adjusted according to the glue packaging instructions). 6. Sweep the ground with a sweeper to remove excess glue.

Note: 1. When installing, pay attention to avoid too much glue on tiles and floor sealing strips, so as not to affect the appearance and fixing effect. 2. When installing the convergent strip, the gap between the convergent strip and the ground should be smooth, and there should be no obvious gap to avoid dust, dirt and other sundries entering the gap.

In short, it is not difficult to install tiles and floor edge banding. As long as you pay attention to the details, the operation process is not complicated, and you only need to complete each step with your heart.