How to install the steel ring of automatic washing machine?

Take the spring and wire hook aside and break the hook a little. Insert the steel wire into the groove, leaving an opening on the side, with the hook up and the spring down (experience gained from blood). Clamp the spring with needle-nosed pliers and pull it down. Don't push to the side when pulling, it will pull out the apron. Put the spring on the hook.

The faucet has a washing machine interface, which can be directly removed without a steel head and directly stuck on the interface of the washing machine faucet.

2. The faucet has no washing machine interface. First unscrew the stainless steel outer ring of the steel head and throw away the white snap ring with four grooves in it.

3. Screw the stainless steel outer ring back to half, respectively loosen the four screws on the steel head and loosen the stainless steel ring.

4, directly to the faucet interface stuck, four screws slowly locked at the same time, the white part tightened, and the thread at the other end of the water pipe was tightened with the water inlet of the washing machine.