Projector, 5. 1 speaker, set-top box, interface diagram, find the real 5. 1 channel connection method.

Home projector and 5. 1 sound system have perfect viewing effect. However, the resolution of the projector is required to be as high as possible, and the minimum is not lower than 720P p p.

Real number 5. 1 connection method:

The HDMI HD interface of the set-top box is connected to the projector HD interface through the hd line.

The audio optical fiber interface of the set-top box is connected to the optical fiber audio input end of the power amplifier through an optical fiber audio cable. (But your amplifier can't see this interface, which is usually the OPT mark of the square mouth. If there is, congratulations are basically enough. Connect the speakers of each channel and put them in the required position to watch movies; If not, please refer to article 3).

Without DTS decoding in the amplifier, a DTS decoder is needed, as shown in the following figure:

The audio fiber of the set-top box is connected to the OPT 1 interface through an optical fiber audio cable. Then connect the 5. 1 output in the figure to the corresponding interface of the power amplifier with lotus wire.

Please communicate if you have any questions? QQ328735 19. It happened that I recently remodeled the 5. 1 home theater with an old stereo.