How to make Chinese clothes

1. Drawing lines: After the cloth is cleaned and shrunken, ironed and smoothed, you can draw the lines, most of the Chinese clothes size is the city feet, the city inches to calculate, so use the old-fashioned bamboo ruler.

2. Cutting: leave out the seams, cutting, the most initial shape of the clothes is this. It looks simple, but in fact there are many techniques, such as stretching the lapel, and moving the cloth a little diagonally before cutting to ensure that the large lapel can cover the sewing threads of the small lapel.

3. Undressing: In order to make the sewing effect of the whole garment more appropriate, let's undress it first~

Dressing the hemline~

Digging out the collar and catching the small lapels

Dressing the small lapels

Digging out the collar and catching the small lapels.

There are two ways of joining the small lapel, the open seam and the dark seam. The open seam is to join the small lapel, and then edit a bright line at 0.1cm of the seam. Dark seam is the surface of no obvious line, I personally like the dark seam a little bit

Cutting lapel plaques, plaques is the hometown of the saying, in fact, is to paste the edge, paste the edge of the cut, according to the position of the dazzling seam folded out of the line, in order to make the lapel flat service.

Look at the relationship of the three edges, the top layer is the small lapel seams, the center is the lapel, the bottom is the lapel placket ~

The clothes will be spread out, open the lapel, to observe the relationship between the large and small lapel, from the picture can be clearly seen, the lapel seam position is higher than the small lapel, which is the lapel sewing can be covered with the small lapel sewing line of the necessary conditions ~

The lapel placket is a large lapel sewing, but it is not the only one that can be used.

Placket hem

Placket hem

After the placket hem is sewn, lay the garment flat and see if the placket can cover the small placket's sewing threads

Relationship between the placket and the small placket's sewing threads: while covering the small placket's sewing threads, you can't cover them too much or the garment will be worn at a slant

Placket hem

Colonel hem

Side of the placket The side of the lapel must be folded over after the side is attached, so that the side can be smooth

While the collar has not yet been put on, the main body of the dress is basically finished, try it on to see if the lapel covers the small lapel at the bias flap, and to see how the overall effect is. Please automatically ignore the effect of the raw edge of the collar, haha~

Only in the collar and the first underarm button position with bead pins temporarily fixed, but you can see that the bias placket is still relatively flat, and the big placket to wear up to cover the small placket seams completely ~ shoulder heap of the remaining amount is not too much ~ well ah, quite satisfied, you can not need to adjust the process, continue the following processes ~

Traditional Chinese style bias placket Details of how the blouse was made

Placing the hem at the slit: only one side of the blouse has been sewn on, the other has not yet been cut and sewn.

The collar, the collar must be made so that the lower edge of the neckline is the same size as the reserved collar circumference, so that the neckline can go on tightly.

Look at the effect after the collar is on, from this picture you can also see that the large lapel covers the sewing line of the small lapel from the neckline.

Skewer the stitching at the collar, plain fabric with the same color thread, the stitching is almost invisible, in fact, I personally prefer a slightly more line point feeling, very handmade

has not yet been finished playing the button strip, thin material sewing button strip, to be in the middle of the button strip with a few additional cotton threads, the button strip only appears to be full.