How to change the broken guzheng string?

(1) First, open the tuning box, and use a wrench to turn the chord pin corresponding to the string to be replaced counterclockwise for 2-3 turns, keeping the chord hole parallel to the chord pin hole.

(2) Loosen the wound strings, grab both ends of the strings, and slowly pull out the strings above the panel.

(3) Then turn the guzheng upside down, grab both ends of the strings, and slowly pull out the strings from the S-shaped sound hole;

2. Install new strings

(1) Take out the spare string, insert the string head from the S-shaped sound hole, and then grab the string head and slowly pull out all the strings;

(2) Turn the zither upside down, face up. Insert the string head into the string hole corresponding to the right head, and pull all the redundant strings into the tuning box;

(3) Insert the string head inserted into the calibration box through the hole on the string nail, which is greater than 1 cm, and then press the redundant string from the outside to the inside, and stick to the string.

(4) Turn the extra thread counterclockwise for 2-3 times, leaving an extra thread on the right side of the thread nail.

(5) The redundant string will naturally form a circle, and the right hand will put this trap on the string nail from right to left.

(6) Lift the string from the top of the panel with the left hand and tighten it, then tighten the string nail clockwise for 2-3 turns until the string on the panel is basically straightened;

(7) Then, install the corresponding Zheng code and correct the sound with a sound corrector.