How to make the joint of braided bracelet?

Tools/materials: braided wire, small bell.

1. First, fold the rope in half, and then tie the knot.

2. Then, you need to put the rope under it, as shown in the figure below.

3. At this time, knitting begins, and the rope is wound like this, as shown in the figure below.

4. Tie the knots one by one, but be careful not to push too hard, as shown in the figure below.

5. Hang the small bell in the middle of the rope, as shown in the figure below.

6. Pay attention to the length of winding weaving like this, and the length is appropriate, as shown in the figure below.

7. Knot the rope and fix it. You need to add beads prepared in advance to the end of the rope and put them on.

8. At this point, you can remove the excess rope, as shown in the figure below.

9. This completes the knitting and looks at the effect, as shown in the figure below.