The three ways to tie a morning sky hook

The three ways of tying a Chaotian hook are as follows:

The first one:

1. Firstly, pass the line through the line hole from the top to the bottom.

2. Then thread the line back through the line hole again.

3. Tie a knot in the end of the line, and thread the line through a couple more times to make the knot a little bigger so it doesn't slip out.

4. Pull the knot down to where the thread hole is, and wrap the thread underneath around the hook a few times.

5. Pull on the longest line.

6.Finally, subtract the thread and the pilothouse hook is tied.

The second kind:

1, first prepare the hooks and fishing line, the line through the hooks, as shown in the following picture:

2, and then circled back, as shown in the following picture:

3, turn up to the pressure of those two lines, as shown in the following picture:

4, from the bottom of those two lines through the middle of this circle, as shown in the following picture:

5, around 4, 5 circles, the effect is as shown in the following picture:

6, pull the line tight, and then cut off the excess thread, leaving 1mm is enough, as shown in the following picture:

The third:

1, take the finished hooks towards the sky a pay, cut off two to three meters of fishing line a section, a small A pair of scissors. It is recommended to choose a hook with a hose as much as possible, of course, if the hose is embedded in the better. Cut off the hose and the hook before attaching the hook (or insert the hose into the hole of the leader in advance), and keep the length of the hose the same as the length of the threading hole of the leader.

2. Thread a seven-star float (waking bean) onto the line, then thread the line through the hole on the inside of the hook shank of the hook, and try to run the line through the hose in order to avoid the lead lump hurting the line.

3. Pull the thread with your right hand and wind it back in the direction of the hook point, then pinch the thread and hook bend with your right hand, and wind the thread back over the top of the hook shank three to seven times with your left hand.

4. Then hold down the wrapped coil and hook shank with your left hand, thread the thread through the single coil, and pull back. During the pulling back process, take care to secure the knot on the outside of the hook shank, and finally cut off the excess thread with scissors.

The Asahi Hook is usually assembled with a main line tied directly into the hook slot of the bottom color, and the buoy is mainly a seven-star mark and a station mark. As the hook and pendant are integrated, when the fish bite, the fish signals are mostly sent to the mark, and only when the individual larger fish such as grass carp, mackerel, carp, etc. bite, the buoy will show as black mark. Chaotian hook is widely used, it is the main fishing tackle for wild fishing. A hand rod with a pair of traditional fishing group, you can deal with the complex natural environment of wild fishing.