Yuba lamp installation wiring diagram

Firstly, determine the construction location of Yuba, and then mark the installation area with necessary marks and horizontal lines according to the size of lamps.

Then install the Yuba lamp bracket to the reserved position and fix it with expansion screws.

Next, according to the wiring mode and power supply wiring of Yuba lamp, choose the appropriate connector to connect the lamp with the wire.

After wiring is completed, put the lampshade of Yuba lamp into the bracket and tighten the screws to fix it.

Finally, turn on the switch, test whether the Yuba lamp is installed successfully, and check whether the installation is firm and not loose.

Precautions:

When installing, it is necessary to turn off the relevant circuit switches in advance to avoid accidental electric shock.

Do a good job in site safety measures to avoid dangerous accidents such as falling objects during installation.

Before wiring lamps, confirm whether the voltage and current match, and protect the interface with insulating tape.