Woodworking how to do 2.8m diameter round dining table surface

Find a wooden strip or something, slightly longer than the radius of this table, take a ruler to measure to 1.4m to nail a nail, with this nail as the center of the circle, on the ground to lay out the table, of course, the nail is nailed to the center of the table of the planks, and then rotate this wooden strip, the length of each piece of wood is just a little bit more than the position of this strip of wood turned to (usually 1-2 inches more, or 3-6 centimeters), so that the length of the planks needed to be fixed, and then sawed, the position of each plank in the order to remember, you can make a good mark, and then spliced together into a large round board. Then use an electric planer or hand planer to plane the boards flat and smooth.

Next, in the back to open 2 slots, on the two strips of wood to do fixed, and finally still use the original nails nailed to the center of the table, nailed to the center of the circle, with a pen along the strip of wood turned to draw a circle, with a saw along the circle will be sawed off the excess part!

The round table top is out! Figure out the rest of the details for yourself!