Simple solid wood bed making method

Wooden bed making process:

Main materials:

Several cedar boards, saws, woodworking planes, woodworking chisels, angle ruler, sandpaper, pencils and so on.

Operating steps:

1, making bed legs. First of all, the purchase of two 8 * 20 * 200 cm square wood material flat vertical for the production of bed legs, in the bed legs every 8 centimeters to open a 2-centimeter horizontal groove. The horizontal groove is used to fix the bed board, open up, and then planed with a woodworking plane.

2, make bed board. Need 20 pieces of 2 * 12 * 200 cm bed board, in the two ends of the indentation of 30 centimeters to mark the position, and the legs of the bed vertically lapped together, marking both sides of the lap width line. Then extend the marking of the other three sides, that is, the left and right sides also use a combination of pen or scribing knife scribing line. Then use the scribe to accurately mark the edges that will be cut to ensure that the boards and legs pass through each other accurately.

3, making bed edge. Two pieces of bed edge size 3 * 30 * 200 cm, if the width of the wood is not enough can be used through the band mortise and tenon splicing. Next began to assemble the bed board and bed legs, due to the production of the size of the slight deviation, so the first one by one to match the appropriate bed board, the size of the back of the inappropriate and then trimmed. After assembled, then use the marker to make the corresponding number, convenient for the next assembly. And then the production of good bed board placed two sides, in the corresponding bed board head end and bed board with round dowel fixed.

4, sanding and painting. First with 180 # sandpaper coarse sand, then with 240 # sandpaper fine sand, and finally with 320 # sandpaper fine sand. After 320 # sandpaper fine sanding parts, basically can not see the sand marks, after doing bright paint will be very smooth. In the past, it was often said that the carpenter was three parts, but the lacquerer was seven parts. That's because in the past, the lacquer used was covering lacquer, so it didn't need to be fine in the structure and sanding. And now the use of translucent paint, mainly to show the texture of the wood, so the treatment of the wood itself is very important.

5, finish.