How to install the pulley and line on the fishing rod

1, twist the knob on the lower end of the rod holder, insert the pulley into the holder, and tighten it;

2, according to the needs of individual casting rod pulley handle left and right interchangeable operation, tighten it;

3, the installation of the fishing line, folded as shown in the picture;

4, folded fishing line line thread and then bent back to the formation of coils, as shown in the picture;

5, the bended threaded into the coil as shown, repeat the previous step, winding 3-4 turns;

6, finished, as shown in the two hands pulling the ends of the knot to tighten the thread;

7, tightening, cut off the remaining line;

8, open the pulley line cup holder, just tied sets of the line cup;

9, tighten the line

10, after fixed, the fishing line After fixing it, the fishing line will go through each component in order and straighten it