How to cut hair with razor mold

1. Tie the front and back of the head with a hair rope, and directly push the side and back of the head with a 3mm long electric pusher. Pay attention to leave some hair between the side, the back of the head and the top of the head, and don't touch it. This part of the hair is finally trimmed to ensure the transition between the two parts of the hair. Pay attention to press the scalp tightly and push it several times to prevent long hair. When cutting the hair at the back of the head, you can only feel the length of the hair with your fingers and repair it.

2. Try to trim the hair on the top of your head with a dental clipper. Where the hair is dense, you only need to cut it with a tooth clipper at the position 1cm above the hair root. If you need to cut it short, cut it a few times with a nail knife at the required length.

3. In the transition area, it can be handled slowly with dental scissors, so that the transition between the two parts is smooth. It's time-consuming. You can also use an electric clipper to clip out a certain length (to avoid accidental hand injury) and gently "brush" the hair in the transition part. The transition area will be smooth after a few more rubs (this method involves advanced skills and steady hands that have been practiced for more than ten years, please try again after more exercise). The transition area from the back of the head to the top of the head is difficult to handle, so it is recommended to repair it slowly with dental scissors.

4. Finally, trim the hair of ears and sideburns. Hair on the sideburns is very important. This part of the hair and the hair on the neck can be trimmed with an electric razor.

5. Finally trim the top of your head and bangs. Cut off the bangs slowly with a flat scissors. It looks comfortable, but it's basically okay. Rinse with water and blow dry.