How to weave a bear bracelet?

1. Prepare a ball of wool, a 6.0mm iron crochet needle, 20 marking buttons and a sewing needle.

Take out a thread and start to tie a slipknot.

3. Thread the crochet needle through the knotted circle.

4. Hold the thread with the little finger and the ring finger, and then pass through the index finger.

5. Wrap the thread around the crochet.

6. Hook the thread out of the back loop with the hook at the front end of the crochet, and then wrap the crochet once.

7. As shown below, the lock needle is ready, and then the crochet needle is buckled on a line.

8. Next, repeat the previous steps 5, 6 and 7, and fasten a lock for each hook.

9. Find the position of the first lock, thread the crochet needle through this coil, and thread this thread on your hand normally.

10, winding and pulling out the coil.

1 1. Hook the first coil out of the second coil.

12. Thread the needle through the position of the first padlock buckle.

13. Wrap the wire and pull it out.

14, repeat 1 1, 12, 13, and lock at each v.

15. At this point, the bracelet is woven.

16 As shown below, hook the bear's ear with another thread.

17, hook the ear and bracelet together with crochet.