How much is a roll of waterproof linoleum? What should I pay attention to when using it?

How much a roll of waterproof linoleum can't give the price. How much a roll of waterproof linoleum costs has a great relationship with the quality and specifications of the product. Moreover, because the main raw material of waterproof linoleum is asphalt, it is often affected by the price of raw materials, and the price of waterproof linoleum fluctuates greatly. The specific use should be reasonably selected according to the actual situation of construction. The price of a roll of waterproof linoleum is subject to the quotation of the local dealer. Here is a brief introduction to the types of waterproof linoleum and the places that need attention when using it.

First, the types of linoleum waterproofing linoleum belongs to flexible waterproof coiled material. There are three kinds: 1. Asphalt waterproof linoleum: after asphalt is coated on the base paper or fiber fabric, powder or sheet waterproof material is evenly spread on its surface. 2. Modified asphalt waterproof linoleum: Adding polymer modified material to the traditional oxidized asphalt increases its application temperature range, so that it can be used in places with harsh environment. The thickness is generally 4-5mm, and the waterproof effect can reach 15-20 years. 3.SBS modified asphalt waterproof linoleum: this kind of coiled material has strong high temperature resistance, and its elasticity and aging resistance are also good when the temperature is more than MINUS 20 degrees and the temperature is as high as 100 degrees.

Second, the use of linoleum construction site at the grass-roots level must be thoroughly cleaned up. When coating the basic treatment agent, it should be coated evenly, so as not to bottom out. When laying an additional layer, the position of the pipe bottom and the angle of yin and yang should be cut into corresponding shapes and covered with a layer in strict accordance with the design requirements. According to the length of the base, the shop is stuck, and the volume is cut for later use. The starting point at the end of the coil should be flush, and the distance between the spray gun and the heating surface should be 300 mm When spraying and baking the coil back and forth, the force should be even and the blank holder width should be well mastered. When hot-melt edge sealing, use a spray gun to heat the lap seam of the coil, press the edge, and squeeze and bond with asphalt. After the construction, the sealing end shall be embedded with asphalt sealing paste.