How to connect the switch to the wired handle?

If it is a switch base, after the switch is placed on the base, two USB interfaces can be found on the side of the base, and there is also a USB interface inside the base, which is connected to a third-party wired handle through USB.

Try to plug it in first. Look at the flashing light, the connection is successful. If the light is not on, click the handle icon on the home page and select Find. After searching for a few minutes, the handle vibrates and the connection is successful.

Connect the charger to the upper jack and the HDMI cable to the lower jack. Then close the Nintendo SwitchDock cover. When the handle is installed in the main unit, select the TV mode, and then remove the left and right handles.

Enter the main interface of the switch, select the handle icon next to Settings, and click Enter.

Method 1: First turn on the switch and enter the "handle" option. Then select "Search Handle" and a dialog box will pop up. After selecting OK, press the small button above the switchpro handle, as shown in the figure.