How catia draws steel wire assembly

Using CATIA software to draw steel wire assembly can adopt the following steps:

1. Open CATIA software, create a new part file and name it compilation network.

2. Select the XY plane to enter the sketch, select the graphics needed for contour drawing, and constrain the dimensions. Copy the sketch.

3. Exit the sketch, create a normal plane, and enter the plane to draw a circle with a diameter of 5. Select the rib to stretch.

4. Measure the key dimension, create an offset plane based on the dimension, and then paste the copied sketch. Draw another rib after adjusting the position.

5. Arrange two ribs to get the picture below.

6. Draw two intersecting ribs in the same way, and pay attention to the key dimensions.

7. Finishing, then intercepting the square woven net of 120* 120, adding materials, and drawing is completed.

It should be noted that the specific operation steps may be different due to the specific product requirements and the actual operating environment, so it is recommended to make adjustments according to the actual situation.