How to make a bench

Bench production methods, details are as follows:

1, material first design sketches, sawing, drilling, installation, the specifications of the stool to be tailored to the root saw body type, the first root saw the design of our bench pattern, first should be in the prepared boards according to the size of the scribing line and then start the material.

2, the production of bench surface bench feet slanting two-way slant mortise and tenon, bench surface and feet of the mortise and tenon production has a certain degree of difficulty, the surface of the bench eye chiseling method for novices to, it is best to be front and back according to the size of the drawing of the line chiseling a model, with a small drill drill through the eye, and then milled once with a large drill, and finally milled with chisel to the eye, so as to ensure the accuracy of the.

3, the production of stool feet sawing, we use a hand saw, sawing wood right hand holding the saw hand, saw tooth tip down, with the left foot will be tightly pressed in the wood on the work bench, in order to prevent the wood up and down or left and right to prevent the wood from bouncing.

4, under the saw should be slow and then fast, when the wood is about to saw, with the left hand to cut the wood ready to hold steady, to prevent the wood along the wood grain tear or fall and hurt the foot. The tenons of the foot of the stool and the cross post are all single-shouldered diagonal tenons, which are not very difficult to make as long as they are scribed correctly.

5, assembling stool side and toe should be in the same vertical line or toe out a little better, to the stool playing eye, to grasp the tongue and groove two-way slant angle, unskilled and slowly play on the line, through the mortise and tenon on both sides of the fight remember to change the angle, installed and then to the stool through the mortise and tenon to play the wooden wedge.

6, the bench do not have to stick to the basic size of the case, mainly in accordance with the requirements of use and ergonomics to determine the basic size, but also can be rooted in the saw of their own existing materials to determine the situation, flexible application on the line.