The installation method of the ceiling teaches you 5 steps will be able to easily handle.

Nowadays, for the kitchen or bathroom ceiling installation has been a very common phenomenon, because it has a good appearance, can be heating, ventilation and easy to install and so on, and by the owners of the favorite. But ceiling installation method exactly how? Many homeowners do not clearly understand. Next I teach you a few steps to help you easily get it done.

Ceiling installation method 1, preparation

Before the installation, be sure to do a good job of preparation, so that the installation can be step by step. First of all, to measure and calculate the size of the ceiling size, generally divided into 300 * 300mm, 300 * 450mm and 600 * 600mm these categories. Next, the height of the installation and the position of the ventilation window should be determined. Then, drill holes with an electric hammer for the arrangement of wires. Finally, according to the size of the room you can draw a sketch of the installation of the ceiling to facilitate the installation of the ceiling.

Ceiling installation method 2, installation of six screws

After the preparatory work is done, you can follow the pre-drawn sketches in the pre-drilled holes to install the required screws. However, it should be noted that the height of the sandwich between the ceiling and the roof shall not be less than 25cm, and the screws should be kept perpendicular to the ceiling.

Ceiling installation method 3, install the keel

The keel is the key to the ceiling, as long as the size of the main keel according to the size of the card in the pendant can be, but also to maintain the level. Then, the triangular hanging piece set into the triangular keel, and sequentially fixed in the main keel, pay attention to the distance between each keel in the 300 mm or so.

Ceiling installation method 4, installation of fasteners

Next, the ceiling connector is installed to the triangular keel has been fixed beforehand, and then cut off the required length to insert it into the other end. After the connectors are inserted, the fasteners can be installed. It is recommended to cut with the help of a hobby knife to maintain the overall beauty and symmetry. Cut the buckle plate in order to card in the triangle keel, and card can be tight.

Ceiling installation method 5, installation of electrical appliances

Finally, it is the installation of electrical appliances. Insert the side of the card spring into the box, and then put the box on the keel, to maintain stability. After installation, carry out the switch test to check whether it is energized. If the buckle plate is flat, electrical appliances can work normally, then the whole integrated ceiling installation is completed.