There are several ways to incubate eggs

I. Kerosene lamp incubator?

1. construction with wood to make a 200 cm long, 100 cm wide incubator, box wall thickness of 7 cm, box wall hollow filled with ?NBD73? stone powder or Styrofoam grains, the box is made into a 3-layer wooden grid, so that the egg plate to maintain a 40-degree incline, the box top can be replaced by a quilt. The front of the box should have 2 doors for ventilation and out of the chick, in the box at both ends of the ground 15 centimeters each have 2 diameter 3 cm iron pipe, the mouth of each put a kerosene lamp, these 4 iron pipe in the box diagonally upward cross from the opposite side of the wear out, wear out and set up a section of the smoke pipe upward. The temperature inside the incubator is maintained by the heat emitted from these four iron pipes.

2. Operation By adjusting the size of the kerosene lamp fire, you can adjust the temperature inside the box. In the bottom of the incubator should be set up water pan to regulate the humidity of the box. Before hatching, the temperature should be pre-tuned, and then into the hatching. The temperature should be checked and adjusted 4 to 6 times a day, and the eggs should be turned over manually 6 to 8 times. The temperature in the incubation room is about 20℃. Pay attention to humidity and ventilation in the late incubation period. Kerosene lamps can incubate pigeons, quails, partridges and other rare bird eggs 3000 at a time, only need kerosene 2?5 kg or so. As long as you have a good grasp of the fire, the same can achieve a high hatch rate, more electric hatching machine to save money, but to diligently observe, diligently adjusted, and to prevent fire.

Two, electric bulb plane incubator?

The production of electric light bulb plane incubator requires 15 watts and 25 watts of electric light bulb each 1, the size of the cardboard box each 1 (large set of small around the empty 4 ~ 6 cm), wood shavings (or hulls) a few kilograms of gauze, sacks, thin quilt each 1, wet and dry bulb thermometer 1, diameter of 6 centimeters or a small bowl or small bowl of 1, diameter 1?5 ~ 2 centimeters or so tubes (bamboo or gelatin), such as two small sections of the material. Because there is no temperature control equipment, so the temperature is more difficult to adjust (Note: such as adding a mercury conductive table temperature control or thermistor thermometer can be used), can be empirical by covering the sack or thin quilt (depending on the outdoor temperature depending on the high and low), or increase or decrease the wattage of the light bulb to adjust the temperature. The voltage is slightly higher late at night, and care should be taken to avoid overheating in the incubator.

Three, hot water heating incubator

By the box, egg tray, hot water bottle and other components. Box by a small cardboard box stacked together, and between the two boxes filled with insulation materials (such as cotton, grain husk, wood chips, etc.) made. Box placed horizontally in 3 to 4 full of hot water glass bottles as a heat source, bottles covered with a wet towel, stacked on both sides of the 4 to 6 small square wooden bars, used to adjust the distance between the egg plate and hot water bottles on its frame, in order to stabilize the temperature of the egg plate at a certain value, egg plate covered with a number of thin cotton pads or towels to keep warm. General volume of 0.3 cubic meters of incubation boxes, about 60 to 100 quail eggs can be incubated. Just heating the water, the water temperature is high, often more than 40 ℃, then the egg plate should be covered with some on the hot water bottle and insulation, not too high a temperature in the egg plate. About 1 hour later, as the water temperature drops more, should be removed from the hot water bottle on the cover to return to cover the egg plate, and gradually reduce the number of wooden strips, so that the egg plate slowly to the hot water bottle close to keep the temperature inside the plate stable. The hot water in the hot water bottle is changed every 4 to 6 hours, which can be done when turning the eggs and adjusting the position of the egg tray.?

Four, hot water hose incubator?

Container length of 95 cm, 83 cm wide, 76 cm high, the outer layer of the corresponding thermal insulation measures need to be taken (with the hot water heating incubator with). The box is divided into upper, middle and lower parts. From the top of the box to the top of the box 31 centimeters from the upper part, from the bottom of the box to the bottom of the box 33 centimeters from the bottom of the lower part, between the upper and lower parts (only 12 centimeters) for the middle part, flat with "eye" hot water pipe. The upper and lower parts can be divided into several layers of egg trays. As the upper part of the hot water pipe above, the temperature is higher, suitable for hatching the early incubation of rare bird eggs, the lower part of the hot water pipe below, the temperature is slightly lower, suitable for hatching the late incubation of rare bird eggs. The hot water pipe is connected with the hot water pot outside the box, and 2 kerosene lamps are placed under the hot water pot. The hot water temperature can be adjusted by adjusting the size of the lamp. Relative humidity can be adjusted by increasing or decreasing the wet cloth on the wooden grill that holds the hot water pipe. Thermometer should be placed in the middle of the box. Generally the upper part of the box can be incubated rare bird eggs about 750.