The craft of paper sculpture practice

Paper sculpture, let the flat paper stand up, give it life, vitality. Today just released a simple paper sculpture production method, to see better and more beautiful, we must open your brain, let fly your mind, you will have unexpected harvest Oh

Tools / Materials

more

a hard a little bit of white paper, a piece of color paper, scissors, rulers, pencils wallpaper knife, glue.

Methods/Steps

1/7 Step-by-step reading

Fold the paper in the center on the table as shown in the picture.

View the remaining 1 images

2/7

Open the paper again, use a ruler to draw dots in the center fold, the distance between the dots is determined by yourself, and it should be even, then turn the paper across, and draw a horizontal line centered on each dot as shown in the image.

View the remaining 3 images

3/7

Fold the paper in half again according to the original fold, and start cutting along the drawn lines, as shown in the image.

View the remaining 1 images

4/7

After cutting, you will see a lot of small strips of the same width, then fold each small strip at the end of the line, fold out the prints, and then spread them out and press them flat, as shown in the picture.

View the remaining 2 images

5/7

Open the paper again, one hand holding one side, the other hand, fold the small strips to the inside, as shown in the picture, fold each strip.

View the remaining 1 pictures

6/7

Take the pre-prepared color paper out, fold it in the middle, then apply glue on the cut paper and stick it on the color paper (the color paper is to set off the three-dimensionality of the paper sculpture), as shown in the picture.

View the remaining 5 images

7/7

Remember to never put glue on the small strips you cut out, so that they are glued and flattened, and the beautiful paper sculpture is ready. Just like a book, when you open the moment, there is a sense of accomplishment.