Correct fastening method of fishhook

The correct way to tie the hook is as follows:

Method 1: Wrap the thread around the hook handle, then slowly wrap it around again and again, and then pull it tightly after leaving the thread end.

Method 2: Wrap the iron wire into two circles respectively, then wrap it under the hook handle, then thread the other circle above the hook handle, then tie it tightly, then wrap the remaining iron wire out of one circle, wear it out, and finally tie it tightly.

Method 3: First, wrap a piece of thread around the head of the hook handle to make the thread form a semicircle, then pull a thread end, put it in, and then wind it out one by one and tighten it.

Method 4: First, wrap a section of wire under the hook handle, then slowly wrap it so that one end of the wire penetrates the ring in the opposite direction, and then the other end of the wire also penetrates the ring, and then tighten it separately.

Method 5: firstly, fix the winding with a ruler, winding a section of thread from the lower part of the hook handle, leaving the thread end to pass through the ring, taking off the ruler after the other thread end passes through the ring in the opposite direction, and finally tying it tightly.

Method 6: First slowly wrap a thread around the head of the hook handle, then select a thread to pass through the ring, and finally tighten it.

Method 7: First, slowly wind a thread from the lower part of the hook handle, with one end passing through the ring, then the other end passing through the ring in the opposite direction, and finally tighten it.

Method 8: First wind a thread around the hook handle, pull one end of the thread to the head of the hook handle, then wind another thread around the thread, then tighten it, and then tie the end tightly.

How to tie a hook

1. First, put the fishing line through the hole of the hook, and then leave a short line on the back of the hook.

2. Bend the line length into a small ring, and then pass the small ring through the hole on the hook.

3, the line length through the small ring, and then tighten. Ensure that the line length passes through the other side of the small ring and is firmly connected with the fishhook.

4. Continue to go down along the main body of the fishhook, leaving a short line under the fishhook.

5. At the end of the line length, form a knot. You can use single knots, double knots or other knots that you are familiar with to ensure that the length of the line is firm.

6, tighten the knot, and ensure that the line length is not loose.

In this way, you successfully tied the hook. Before fishing, remember to check whether your tie is firm and adjust the length of the fishing line as needed. According to different fishing situations and personal preferences, there may be other hook and tie methods to choose from.