What should I do if the system installed from the USB disk cannot be started and PE cannot be entered?

To solve the problem that the USB disk installation system cannot enter the PE system: 1. Set the ata setup to IDE mode in the system bios.

This is what needs to be tried first.

Because if the hard disk mode recognition is incorrect, the winpe system will not be able to enter.

As shown in the figure: 2. Repartition the hard disk, and set the first partition as the primary partition and the active partition, that is, the active partition; set the remaining hard disk space as an extended partition, and then divide the extended partition into multiple partitions.

A logical partition, such as drive d, drive e, drive f.

Here you can directly use the diskgen hard disk partition tool in the USB flash drive.

3. Replace the USB boot disk creation tool.

During a system installation process, I used ultraiso to create a USB boot disk for the first time. However, I found that although the prepared USB boot disk could be booted normally, PE could not be entered! This was a problem! Because winpe could not be entered.

Selecting the first option "Install xp to the system C drive has no real response.