What are the steps to install the faucet? Will it be complicated?

1, change the axis of the faucet, know yourself and know yourself, as well as repairing the faucet. If you want to repair the water leak in the faucet, you must know the cause of the water leak. If the axial gasket in the faucet is worn, loosen the gland bolt with pliers, then take out the axial gasket and replace it with a new one.

2. If the water stop tape is damaged, fasten the faucet, then take it off counterclockwise with a wrench, and then roll it clockwise with the wind-printed tape with threaded holes for six times. When you're done, twist the tap again, and then turn on the switch to see if it leaks.

3. The faucet interface leaks. Remove the cover nut of the faucet, and then retighten or directly replace the new U-shaped washer.

The extended data are classified according to the installation height of the sprinkler, and one * * * can be divided into two categories.

Hiding the shower head is a way to expose only one shower head, and the shower panel exposed to the water is buried in the wall and cannot be seen. The center of the wall outlet receiving the shower head should be about 2. 1m from the ground. The distance between the shower control switch and faucet and the ground should be controlled at about1.1m. This is also the most common installation height of sprinklers.

This type of shower head is also the most commonly used product. All installed outside the wall. This product is more convenient in actual decoration. There is no need to consider the progress of the mud tile construction stage. You can completely consider installing it later. There are also many products to choose from. Therefore, most friends will choose this kind of lifting rod shower.