Installation steps of intelligent door lock

The so-called first step is to remove the traditional mechanical lock on the original security door. This paper will introduce the installation steps of smart door lock in detail to help users better understand the installation process of smart door lock.

Remove the traditional mechanical lock

Remove the traditional mechanical lock on the original security door.

Measurement data of door panel and lock body

Measure the width and thickness of the door panel and the new lock body, and mark the opening on the security door according to the volume of the existing door lock and the position of the bolt.

Open cutting

Cut the steel body of the security door with an angle grinder or grinder.

Installation and calibration of lock body

Fixing the lock body requires secondary calibration before it is completely fixed. The position of the lock tongue should match the original door frame, and be accurately measured with calipers and level meters. The door lock cannot be tilted, and the door lock is not vertically aligned, which does not affect the use and aesthetics.

Installing front and rear panels

The lock body and the panel need to be fixed with large bolts, and there is a connecting line between the front and rear panels, thus forming an intelligent lock. In addition, waterproof rubber pads need to be installed.

Trial+password

After debugging, you need to set the smart door lock, modify the original password and input the fingerprint information of the administrator. Any operation requires a password or fingerprint to determine its administrative rights.