How to tie a knot with a string of beads?

Bead bracelets are knotted with ropes;

1. Thread the two ropes on the right through the two knots on the left.

2. Slowly move the crystal beads to the top of the left rope. Be careful not to move too many beads at a time to prevent them from falling off. Just move 2 or 3 beads at a time.

3. Then tighten the knot on the left side of the bracelet, tie two knots between the two knots on the left side and the two knots on the right side, and pull the rubber band after each knot to check whether it will come loose.

4, and then cut off the excess rope, be careful not to cut the knot, otherwise the bracelet will come loose.

5. Pull the knot into the hole of the first worn bead on the right, so that the knot cannot be seen from the outside.

Beads should be tied with auspicious knots, and the auspicious street will send them as follows:

Need tools: bead chain

First, prepare a line and pull the left and right sides of the line into two ear wings.

2. Turn up the two ropes below and press the right ear wing.

Third, repeat the second step one by one counterclockwise.

4. Thread the left ear wing into the gap left by the two ropes below.

Fifth, tie the knot.

Six, clockwise, starting from the above two lines of rope, repeat the above steps to make a circle.

Seventh, tighten and arrange the knots.

Eight, pull out the ear wings, adjust the number of rows, pay attention to the outer ear can not be too small, so as not to loose, sort out all seven ear wings, and make a complete auspicious knot.