Handicrafts Video of flowers made with fine wire and sock tubes

Preparation materials: stockings, 24# wire, 18# wire, several Polygonum rosebuds, 3 sprigs of maitake, 6 slices of jade goat's teeth, 2 sprigs of eucalyptus. 2 pieces of oil soil, 1 flower pot. Green paper tape.

Making steps:

1.1 rose flower material preparation as shown. First, divide the 24# wire into 4 equal parts. (about 18CM)

2. Make the flower bud (flower center): stick a little white glue on the 18# green wire and put it into the Polystyrene rose bud as shown in the picture.

3. When the Polystyrene buds are dry, put on the first layer of red stockings, and tie the bottom end with QQ wire twisting.

4. Put on the second layer of burgundy stockings.

5. Again, tie the lower end tightly and secure. The color of the two stockings is more saturated.

6. Make the leaf shape: first use 24# green wire to wrap around the hair plug about 9 turns.

7. After pulling out the hair plug, pull the wire about 20cm long.

8. Cross the ends of the wire.

9. Twist the wire several times with a pair of sharp-nosed pliers to hold it in place.

10. Put light green stockings on the first layer and dark green (satin-dyed green) stockings on the second layer. (Steps in order from left to right)

11. Wrap with green paper tape.

12. Make 3 leaves in the same way and combine them as shown.

13. Make petals: take 24# gold wire folded round (18CM ) .

14. Twist with sharp-nosed pliers to fix.

15. Petal molding diagram (can be compared with the size of the left leaf shape).

16. Put on the first layer of red stockings.

17.Wrap QQ thread to fix it.

18. After wrapping the QQ thread, cut off the excess stockings.

19. Put on a second layer of burgundy stockings and cut off the excess stockings in the same way. This completes one petal.

20. Repeat the same process for 10 petals.

21. Combine the flowers: Combine the center of the Polystyrene flower with one petal. (Wrap and tie with QQ thread)

22. Add a second petal.

23. Cross the two petals and fold out the bud shape.

24. Then add the first petal of the second layer.

25. Then add the second petal of the second layer.

26. Add the third petal of the second layer.

27. Remember to tie with QQ thread.

28. Wrap the first petal of the third layer in the same way.

29. The third layer **** has 5 petals, as shown in the picture stagger each other to be beautiful!

30. Wrap the green paper tape around the base.

31. Green paper tape continues to wrap up to 1/3 of the wire.

32. Wave the rose petals and pinch them to shape.

33.Combine the rose leaves you made earlier.

34. Single rose finished.