What are the advantages of electric underfloor heating over traditional underfloor heating?

Electric underfloor heating, what are the advantages of electric underfloor heating over traditional heating? Compared to traditional heating, electric floor heating has obvious advantages: first of all, the room temperature distribution is uniform. The use of floor heating, because the entire floor uniform heat dissipation electric floor heating, so the temperature difference in the room is extremely small. And the indoor temperature is gradually reduced from the bottom up, the ground temperature is higher than the temperature of the human respiratory system, giving people a comfortable feeling of warm feet and cool head.

Often the traditional heating methods, especially burning coal of this kind, not only produces a lot of dust, harmful gases, but also leaves a lot of residue, the human body and the environment are not good. There is also a little cost is also higher. The electric heating is different, the use of electricity, and the circuit is safe, developed, will not pollute the environment, will not affect people's health and so on.

Electric heating and other heating methods, compared to most of the need to lay in the ground, installation is simple, the choice of materials need to be the kind of better, because of the later maintenance and so on are more trouble, so from this point of view, the cost is not very low. But electric heating is used for a long time, and the comfort level is also particularly high, whether it is from the economy or from the comfort point of view, is relatively good.

Electric underfloor heating is a little thinner than the water underfloor heating we commonly use, which is quite practical for those neighborhoods with large floor heights. At the same time, electric underfloor heating is able to save about 5% of indoor space compared with traditional underfloor heating.

Electric underfloor heating installation method:

1, first lay the underfloor heating insulation board to prevent the heat from passing downward. Pay attention to clear the ground before laying the insulation board.

2, insulation board laid after laying floor heating reflective film, the role of the reflective film is to reflect the heat upward.

3, laying silicon crystal mesh, the role is to prevent the heating cable heat plunged into the insulation layer inside, in addition to strengthening the cement layer firm.

4, laying heating cable. Note that the heating cable can not be arbitrarily cut or spliced, must be the whole roll of paving, so be sure to calculate the spacing before laying. The spacing is calculated as follows: the area laid / length of the heating cable.

The laying area here is the area of the place where the heating cable is actually to be laid. For example, a room measured out to be 15 square meters, but the closet is not laid under the closet, then the area of the closet should be deducted. Assuming that the closet area is 1 square meter, then the actual laying area is 14 square meters. Then remove to the length of the cable.