How to make the lines follow the components in PCB routing in Altium Designer

How to use Altium Designer's PCB wiring to follow the components: After the PCB wiring is completed, drag the component lines to follow them: Use the Drag TrackEnd command in the Move command. Click on the component to move, and the lines will follow.

PCB (Printed Circuit Board), the Chinese name is printed circuit board, also known as printed circuit board. It is an important electronic component, a support for electronic components, and a carrier for electrical connections of electronic components.

Because it is made using electronic printing, it is called a "printed" circuit board.

Extended information: Relevant requirements for Altium Designe: 1. Altium Designer integrates FPGA design and embedded system software design functions on the basis of inheriting the functions of the previous Protel software. Altium Designer has higher computer system requirements than previous versions.

.

2. In addition to fully inheriting the functions and advantages of the previous series of versions including Protel 99SE and Protel DXP, Altium Designer also adds many improvements and many high-end functions.

The platform broadens the traditional interface of board-level design and fully integrates FPGA design functions and SOPC design implementation functions.

3. Altium Designe provides designers with a new design solution by perfectly integrating schematic design, circuit simulation, PCB drawing and editing, topological logic automatic wiring, signal integrity analysis and design output, so that designers can

Design easily and skillfully use this software to greatly improve the quality and efficiency of circuit design.