Wedding flower arch specific production method

Seems like I have to be the first to answer your question, I'm a wedding party, I still know a lot about this kind of arch

First of all, you need to make the base, which is used to support the base of the arch, you need two pieces of tin, and then weld three base slots on the base tin according to an equilateral triangle (round steel components diameter is larger than the support columns)

Make the support columns, made of three round steel components with a diameter slightly smaller than the base (2 support columns*** need 6 round steel components) also using equilateral triangle welding welding using steel bars as the welding point of the 3 round steel structure length 1.70M

Finally, the production of arch components Selected 3 diameter and the diameter of the base slots of the same round steel structure components Beforehand, the 3 round steel into a round arch with a certain amplitude, or using the principle of equilateral triangle, and then use the steel bars to weld the arch. The principle of the triangle and then use the steel bars to weld the connection arch distance of about 40CM

The last step Choose and base slot diameter of the same round steel length of 10M ***6 welded to the round arch at both ends of the role of the support column connection

Arch decorations in the Internet there are a lot of corresponding picture information here do not do not do too much to explain

If there is any place I do not understand. place Add my QQ165636528 consulting

.