Traditional Culture Encyclopedia - Traditional stories - Midea old-style range hood disassembly method
Midea old-style range hood disassembly method
Old range hoods are likely to lose their effectiveness quickly with use and even sometimes cause circuit failures due to the length of time they have been in use. Therefore, knowing how to disassemble and reinstall an old range hood is one of the basic skills that every resident should have.
Here's how to disassemble an old range hood:
1. Prepare the tools you need
There are some basic tools you need to disassemble an old range hood. These tools include screwdrivers, wrenches, calipers and cutting tools, etc. Make sure the tools are clean and accurately equipped.
2. Disconnect the power supply
Before you start dismantling an old range hood, the power supply must be disconnected. This can be done by turning off the circuit switch or disconnecting the power from the mains. Ensure that the appliance cannot be harmed by coming into contact with the power supply during dismantling.
3. Remove the old range hood cover
Remove the hood from the wall or ceiling. To remove the hood, use a screwdriver to remove the screws on the bottom of it, then push the hood upward to free it from the base. Before removing the hood, take care to double-check the wires it's attached to, to prevent the wiring from breaking during removal.
4. Disconnect the wires
Disconnect the wires if necessary. The terminals are usually located near the motor. Use a pair of caliper pliers, 03 alloy scissors, etc. to cut through the protective coating of the wires, and then use a wrench to loosen the wire clips. At this point, it is important to mark the color of each wire so that they can be properly connected to the correct terminals during reassembly.
5. Remove the Oil Cup and Swing Arm
Remove the smoker or swing arm if parts need to be cleaned, inspected or replaced. Loosen the Phillips screw next to the smoker to remove the swing arm from the smoker, then remove the oil cup.
6. Schematic assembly
After unfolding the diagnosis, the old range hood can be reassembled and reinstalled. After thoroughly cleaning and inspecting each part, assemble them back into place. Make sure that each wire is connected to the correct terminal.
In conclusion, disassembling an old range hood requires some skill and technique, but the correct use of the proper tools and the right steps, the exact steps, can ensure a successful disassembly and reinstallation. If you are unsure of how to correctly solve a problem, recruit a professional technician to help you disassemble and reinstall your old range hood.
- Previous article:What impact does the epidemic have on China?
- Next article:How to nurse after adenoidal hypertrophy in Shanghai Hongkang Hospital?
- Related articles
- Where is the short video material of mobile phone?
- How to calculate the cornice corner map of traditional quadrangles
- How to fry dry tofu is delicious salty and slightly spicy sharp pepper dry tofu down to practice
- Combination of traditional dishes with Hubei characteristics
- Costco, the largest supermarket in America, or Wal-Mart?
- Do you know the style characteristics of impressionist painters?
- Which company is the developer of Taicang Fahuatai and Taicang Courtyard?
- What is the traditional international system?
- Tibetan stove
- What is the direction of the twenty-four mountains?