Multicolored rope making method video

Method 1:

Material: a jade red line 180cm, multicolored line 160cm.

1. Fold the multicolored thread in the middle for buttonholes, leaving about1.8cm..

2. Take multicolored thread as the core thread in the middle and red thread on both sides, and start knitting. First put the multicolored thread in the middle, and wrap the multicolored thread around the red thread at the bottom.

3. The red line above is wrapped around the index finger, as shown in the figure.

4. After the red line bypasses the index finger, pull it up and pass through the coil. As shown in the figure.

5. Tighten the red thread below, remove the coil and twist the knot.

6. Turn it clockwise. After pulling down the red line around the index finger, pull up the line and pass through the coil.

7. Repeat the above steps.

8. Tighten the red line as shown in the figure and repeat the above steps all the time.

9. The red line can be 2cm long.

10, let's start knitting with multicolored thread.

1 1, the method is the same, that is, put multicolored threads where the red thread is woven.

12, after editing for a short period, you can see the effect.

13, colorful places are coded to1.5cm.

14. Repeat the above steps, with 4 colorful segments and 5 red lines, and the length of the knot is 16cm.

15. Make up a knot at the end.

16, it looks good after editing, with bright colors and just the right thickness.

Method 2:

Tools: Lighter colored rope.

1, weave 5 strands and 5 wires from the middle.

2. When it is almost big enough to button, fold it in half and take one of the threads to make a button. At this time, each color line becomes two!

3. Fold the previously prepared threads in half, buckle the threads of the same color together and weave them into four strands.

4. In addition, take a red jade thread of about 40cm and tie a flat knot on the four strands that have been braided before. Pay attention to weaving five strands of four strands on the same plane, and the arrangement of five colors should be in the order of green, red, yellow, white and black.

5, flat knot woven into your favorite length, you can cut off the combustion.

6. Weave the four strands into an appropriate length.

7. Take another 40cm jade thread and tie a flat knot, which should be consistent with the length in front.

8. After flat knot burning glue, straighten the line.

9. Leave five different colored lines on the left and right, and cut off and burn the remaining 10 line in the middle.

10, cut off the fuel rod after adjusting the thread.

1 1. Now we have finished weaving colorful ropes.