Red rope braided gold bracelet style.

Tools/raw materials: gold beads, red rope, jade beads, scissors, lighters.

Steps/methods:

First, prepare four red ropes and tie a knot 5-6 cm from one end of the line.

Then divide the long end into four lines, the first line is higher than the second line, the second line is higher than the third line, and the third line is higher than the fourth line.

Finally, the fourth article starts from the first line.

Tighten the four wires as shown.

Repeat the above steps, the effect is shown in the figure.

After a while, put on the golden ball.

Then continue to repeat the compilation. The first knot must be tightened to fix the transfer bead.

After knitting for a short period, put on transfer beads and continue to repeat knitting.

After knitting, take apart the knot just tied on it, as shown in the figure.

Take a rope from each side and tie a knot around the other ropes.

Leave two ropes at the back end, cut off the extra ropes and burn the edges with a lighter to avoid scattering.

Then prepare two jade beads. After the beads are put in, tie a knot and burn the ends with a lighter. Use the same method at both ends. Then connect the two ends of the rope to cross and start knotting. After repeating the above method, cut off the excess thread and light it with a lighter.