Hook shoe tutorial

Material preparation: wool, needles, etc.

Operating steps:

1. First, lay the foundation. The starting point is on one side of the shoe. Thread the crochet needle through the bottom line, hook the wool, and then hook the thread out from under the bottom line. Hook the wire, pull it out of the coil and tighten it properly.

2. Hook out the bottom thread, wind the thread around the needle, and pull the thread out of the two coils. This is a short stitch, and the bottom line is hooked with the same stitch.

3. Start hooking the vamp, and put the crochet needle directly through the adjacent hole. Wind the thread on the crochet, hook the crochet on the thread, and pull out the hole from under the thread to form two loops. Pass the former through the latter to form a coil.

4. Hook the crochet at the thread end, pass through the coil and take out the crochet. Tighten the thread, but don't cut it yet. Upper 1 hook.

5. Start to hook the second row, and the needle threading position is on the right side of the lifting pin hole in the first row, separated by 1 pin hole. Take the wire out of the hole and wind it into a coil. Wind the thread on the crochet, take the thread out of the coil and tighten it properly to complete the second row of stitches.

6. When closing the needle, put crochet into every two holes, and the needle insertion method is the same as 1 row.

7, then hook the rest in the same way, you can add patterns, novices suggest hooking the hand without flowers first.

8. A slipper was hooked.