Traditional Culture Encyclopedia - Traditional stories - How to use and maintain fishing rod to prolong its service life?
How to use and maintain fishing rod to prolong its service life?
Many fishermen are not aware of the maintenance of fishing rods, so they simply wipe them or put them away after fishing, resulting in a lot of moisture and even sewage, and humidity, high temperature, salt and small dirt are the four major factors that hurt fishing rods; We have done an experiment to simulate the situation that the pole is in the trunk of a car (up to 60 degrees) after freshwater fishing and sea fishing by putting it in a salt fog box with high temperature, high humidity and normal temperature. As shown in the figure:
Simulating fishing and putting the car in the trunk
After 7 days, it appeared: the back plug could not be opened by corrosion and oxidation, the rod body was moldy and smelly, and the paint surface was blistered; And it quickly ages and becomes brittle, mainly because the inner wall of the pipeline is not protected. There are tiny particles on the inner wall of the joint, which will wear the joint like sandpaper when rotating and fastening the joint in the next fishing, resulting in uneven stress, blocked force transmission and easy to break the rod. Look at this example:
The back wall is rusty and cannot be opened; Moldy and smelly
The fishing rod bubbles locally and turns yellow after aging.
Drill pipe sealant falls off.
The pole mouth is stained, the joint is not firm, the force is uneven, and it is easy to break.
Why and how to maintain it?
The core of maintenance is to keep it dry and clean, and don't store it at a temperature higher than 40 degrees, so as to keep the fishing rod from aging rapidly and have a simple life.
The best way is to wipe the pole with a wet towel before closing it, and then dry it with a dry towel. However, in fact, it is very difficult to do this. The mentality of fishing friends is basically the same. It is rare to arrange a time to come out. They always fish as much as possible, and then they will end up in a hurry. When they get home, they will be too lazy to move, or they will forget after the time.
The daily maintenance steps are cleaning-dehydration-drying-air drying-oiling; We know that fishing rods are tubular; The narrow internal space is not conducive to water discharge, and the internal carbon fiber cloth is exposed, which is more likely to be eroded without paint protection; In particular, the rock rod can not be disassembled, and it is more difficult to drain moisture. The existence of salt accelerates corrosion and aging.
Where is the difficulty of maintenance?
Dehumidification of inner wall is the most difficult in the whole maintenance process; The traditional natural air drying method is the most time-consuming and greatly influenced by the environment, especially in low temperature and humid weather; Although convection wind and heating can be formed by blower, heating is not easy to control, and it is still difficult to deal with slender sections; The operation is also complicated and time-consuming; There was no such dehumidifying equipment on the market before, and the harm was regarded as normal over time.
Intelligent fishing rod dehumidifier, technology breaks the tradition, is very convenient for the maintenance of fishing friends, solves the problem of dehumidification of inner wall well, and is simple and convenient to operate There is no need to take out the internal connector, just insert it into the air hole of the equipment through the adapter, and the equipment will start and stop automatically; Realize the overall operation, one action, and it can be completed in 5 minutes.
Fishing friends will ask, isn't the intelligent fishing rod dehumidifier just a hair dryer?
According to a certain classification, it can be said to be a hair dryer, depending on how you define it. For example, ordinary household humidifiers become smaller, which is the water replenishing instrument, which is the technology; Ordinary mobile phones plus touch fingerprint cameras are smart. Realize the super maintenance experience of dehumidification in "one action, five minutes", and the intelligent fishing rod dehumidifier is designed in full-pressure dehumidification mode, plug and play; This combines more intelligence and technology:
The design of large wind pressure and large air volume ensures that every gap in the narrow space of the fishing rod has enough air volume. Adopting vibration frequency conversion design, the problem that the inner tube wall is attached like glass is solved, and the rod is also guaranteed not to be blown. Through the adapter mode, it fully adapts to various modes of long and short rods with different weights and calibers, and is protected by air clips, so as not to slightly damage the rod body and the rod body. Under safe conditions, it is moderately heated and dehumidified. Intelligent technology: pressure sensing detection, temperature control, etc. The purpose of a series of technical integration is to make maintenance simple and convenient, and improve the experience of fishing friends.
What's the difference between a smart fishing rod dehumidifier and a hair dryer?
I maintain it, but this equipment is not used.
First of all, the fishing rod and his wife's face and car are the same, and maintenance can delay aging and protect the face; But there are many ways to maintain it, depending on personal habits, interests and time:
Careful fishing friends will wipe the rod with a wet towel before collecting it at the scene, and then dry it with a dry towel. This is the best maintenance. Go home and put it indoors. Fishing friends who like to tinker with their work afterwards, it seems that many fishing friends like to go online to study parameters and buy poles, from which they can have fun and kill two birds with one stone. Fishing friends who fish 1 or 2 times a month come back to wash and brush once, and then dry for a few days. Like to taste new things, fishing rods are updated faster than aging. Generally speaking, with the passage of time, fishermen gradually get to know each other better, and their pursuit of fishing rods will be more demanding. After all, the feeling of fishing is very important, which is a direct feeling; Therefore, the satisfactory fishing rod will be specially cared for, especially the sea fishing rock rod, which needs more care to reduce the damage to the fishing rod.
Maintenance is an attitude, but also a state of mind.
Maintenance is like taking children to learn to swim and rest ashore. Adults always want to dry their bodies with towels. First of all, he will catch a cold when he is wet. Even if he is hot, he will not catch a cold easily. When he is wet, it looks unreliable. The reason for not being practical is not only the cold, but also the love for children.
Fishing itself is entertainment and feelings. Fishing rod is the favorite thing of fishing friends, especially experienced fishing friends. Protecting what you like is an attitude. Maintenance is a sureness, isn't that what we need? !
Accept progressive and cutting-edge things with an open mind.
Embrace technology, technology can change the way we fish and entertain, give technology time and efficiency, make maintenance easier and increase experience and feelings. This may be a very pleasant thing.
- Related articles
- What are the customs of Miao nationality?
- What are the benefits of Zhejiang manufacturing certification
- Which firing house is not included in the predecessor of the Maotai distillery
- What are the corporate culture contents of the company?
- The program is discontinuous after Siemens 802dsl is changed to semi-closed loop
- What types and styles of surgical lights are there?
- Is Heilongjiang the commodity grain base and the most important forestry base in China? Why?
- What are the labor projects?
- Stay angry! Interpreting Middle-aged Man and Understanding Man's Anger
- Which national festival is the Tonggu Festival?