How to print the crease line in the flat expansion diagram of PS packaging box?

The designed packaging box generally has six sides.

Gift: It must be red.

Toothpaste: clean, green, white and blue.

Drugs: mostly white, green and white.

Food: mainly warm colors, no blue (if there is blue as a special case)

The length of the net size when the document was created.

Draw auxiliary lines: draw auxiliary lines where there are creases or cuts.

Do Photoshop well, save it in CMYK TIF format and save it in Illustrtor.

inlay

Make the plan of the packaging box, create a new layer to build a template, and then export the picture effect.

draw

Die-cutting board: dotted line is broken line, solid line is tangent line, and box edge is tangent line.

Line width of die-cutting board: 0.3- 1pt, and cannot exceed 1pt.

Select the first line, double-click the black arrow to copy a few lines, and check whether it is a dotted line in the stroke.

Mouth dotted line

The plan has no shape, and the die-cutting board cuts out various shapes.

First throw away the die-cutting board and save the scheme in ai format.

After recovery, throw away the floor plan and save the die-cutting board in ai format.

Use the plan to make the effect diagram, and then export the RGB mode in jpg format.

Create a new A4,210 * 297 RGB document.

After opening the die-cutting board, pull the auxiliary line and throw away the wired part.

Draw the selection with the rectangle tool, cut all three selections with ctrl+shift+J, and sum them with diagonal cuts.

Deformation operation

abstract

Packaging design includes: 1: plan (for printing)

2. Translation

3: Die-cutting board (for cutting)

1: The first step is to draw a schematic diagram, including the name and size of each face.

2: The thickness of the round packing box is 5mm or 1mm-2mm.

3. Bleeding should be considered in the scheme design, and the bleeding around the front of the packaging box should be 1mm-

2mm

4. Make the packing box with ultra-high-speed drawing circle, fold the part and then make the part.

5: When drawing (packaging box development drawing), take the front of the packaging box (the main surface is the main surface, and the main surface is the front surface).

6: Wire cutting (suit color)

Die-cutting board (it is best to put the die-cutting board in Illustrtor)

Fold line, cut line, no size

The line thickness is 1pt, and the line offset is used.

The renderings are made in Photoshop.

1: Pay attention to the perspective point.

2: 100- 150 pt will do.