How to make a simple prop door, similar to this, material waste paper box, tape.

Materials: waste paper, gummed paper, scissors

1. First, make the three drawers on the right, cut out the cardboard used as the drawer frame, lay the bottom with white tape and assemble them. The side plates of drawer sleeves are made of two layers of cardboard, and a layer of cardboard is added between each drawer sleeve, so that the corrugated direction is matched vertically and horizontally to increase the bearing capacity.

2. Make the frame of a small cabinet with a side door on the left, in which the depth of the outermost cardboard is about 7mm more than the frame (that is, the thickness of a cardboard), so as to finally install the backboard.

3. Next, make a cupboard door and add a layer of cardboard to the inside of the door by using the crease of the carton. The cupboard door should also be laid at the bottom first, and the surface tape should be attached, and then the cupboard door should be attached to the side wall of the frame.

I made a small shelf with two floors and counted it as a partition in a small cabinet with a side door. The width of the small shelf is smaller than the frame width of the small cabinet by the thickness of a layer of cardboard (that is, the thickness of the newly fixed cabinet door cardboard), so that the small shelf can just fit into the frame of the small cabinet. The backboard of the whole frame should be installed after putting the small shelf into the small cabinet, otherwise the small shelf will be difficult to install.

5. Make three drawers. I made the drawer part smaller than the frame, and then I made an extra drawer outer plate with the size close to the drawer sleeve and stuck it on the outer layer of the drawer, which made it look smaller and more beautiful, and the drawer was easier to draw.

6. Make the final finishing touches, stick a small flower belt outside the cabinet and install a handle on the door of the chest of drawers, and you're done.