There are six wires in the light box, two incoming wires, and the remaining four are two switches, which can control the light. How to connect the wires?

Is it the kind of architectural bedroom with a switch at the door and a switch at the bedside? How do you want to use it? Do you want the switch on the door or both? If you want them all, you have to connect them in the form of "double control", and each switch box has a missing wire. ?

Put another wire between the two switch boxes and the light box, and throw the wire as shown below. The light green one is the wire connector.

When installing, buy two "single-open and double-control switches" to install. As shown in the figure, the red wire is connected to the wiring hole (l, COM) in the middle of the dual-control switch, and the two blue wires are connected to the wiring holes on both sides of the switch.