How to set up TE4-RB 10W intelligent thermostat and heating system?

Click Settings. Then, press up or down to set the temperature you need. For example, the left arrow is a quick shift. If you hold down the arrow, the temperature will rise from 0 to 120 degrees, and then the sensor "thermocouple/resistor" will display the detected temperature. If it is lower than the set value, it will automatically output a shutdown signal to control the heater to work and make the temperature rise to the required temperature. If it is higher than the set value, the instrument will automatically output a control signal and turn on the switch in the fan or faucet to cool down.

Speaking of some instruments, they are only controlled by the unit, that is to say, they can only go up, not down, and slowly cool themselves by time, which has a large control deviation. Temperature control instruments with upper and lower limits require smaller deviation.

For example, set 100 degrees, below 99 degrees, heat dissipation, above10/degree, heat dissipation.

SV is the set value, and PV is the temperature of the detected object displayed by the sensor. OUT is low level output control, and AL is over limit. At 10. This is a time automatic setting parameter. OUT and AL are not bright, indicating that the temperature is stable. A short period of no light indicates that the temperature change is poor when heating, which is a time difference. It is impossible to turn off the signal heating all the time, which will cause too much buffering. That is, heating 10 minute, stopping for 3 minutes, heating again 10 minute, stopping for 5 minutes. The time may change, and the time difference is automatically calculated according to the temperature change range of heating once.