How to do ceiling light trough?

1, materials: wooden square keel, paper-faced gypsum board, putty paste or putty powder, latex paint, rows of nails, self-tapping screws, wires, snake skin light tape and spotlights.

2. Plane the wooden square and brush on the fireproof paint.

3, pop up the ceiling level line on the wall and fix a few longitudinal keels on the top first, as needed.

4, make the keel frame, can be nailed on the ground first, if the shaped top should be joinery board to make a model.

5, use the boom to fix the wooden keel, and pay attention to adjust the level and verticality.

6, reserved for the lamp base plate or lamp slot position.

7, by the wire connected, and leave the head.

8, the cut gypsum board with self-tapping nails fixed.

9, screw the protruding screws in place and spot brush two times of anti-rust paint at the nail eyes. In the gypsum board joints with special embedded elastic putty embedded joints, and then use "indeed" cloth paste surface. Scrape putty, sanding, brush latex paint.

10, installed on the strip and spotlights can be.

I hope my answer is helpful to you.