How to use PS to make the picture more Chinese style

This tutorial is more complex, want to learn the partners can watch carefully! First look at the effect of comparison , as shown in the figure below. We use photoshop cc to open the raw format of this photo, enter the camera raw color interface, open the original picture we found this picture background is overexposed, the color is not good. Chinese style is partial light tone and a little green, so here a little fine-tuning, adjusting color temperature, color tone, highlights and so on. It should be noted that the lower saturation, natural saturation and clarity of the operation is the most important. Adjusted as follows: we adjust the light, into Photoshop and then continue to adjust. We found that the character skin color is on the dark side, especially the hands and face, because the Chinese style of the characters visually more flat some, so the need to brighten the dark parts. Practice is, ctrl + j in the background layer on a copy of a layer, adjust the new curve there, the picture for the curve to brighten. Then use the eraser and brush tool on the skin outside the place to erase and repair, only a little bit of skin, can not brighten too much, the formation of a mask, and adjust the transparency of the layer 30%. Figure: ctrl + j copy layer 1, move to the curve layer above, the implementation of Image - Adjustment - color removal, and then the implementation of Filter - Stylized - Find Edge. Then the implementation of this layer Filter - Gaussian Blur, blurring factor 1.5, the purpose is to make the outline of the lines softer. This layer is set to "overlay", layer transparency of 83% (specific transparency according to different pictures are different). shift + ctrl + alt + e snapshot a layer of semi-finished products, as a new layer, the implementation of the filter - special blur - blur coefficient, blur radius 42, threshold, blur coefficient 1.5, the purpose is to make the outlined lines softer. Blur radius 42, threshold 25. will be set to "light color" layer, adjust the transparency of 40%, the purpose of this layer is to make the picture more soft a little. shift + ctrl + alt + e snapshot, a new layer, named "ready to paint layer". The new layer is called "Prepare to Paint Layer". In this layer, we will use the erase tool for some imitation hand-painted soften the paint, from now on is to spend time and effort when, need to hand, skin, and hair to paint, here need to pay attention to the intensity of the paint should not be too large, I generally use 15-20 or so intensity to paint. Slow work, slowly on all the details of the place to apply, here to save a few hours of unbearable time and a handful of bitter tears. Finally, a little bit of facial face liquefaction, and finally merge the visible layers, the whole Chinese-style photo is fixed. Finally look at the picture after the repair. In fact, I want to say is that this post-steps, although not much, but it is very hard and time-consuming, the most critical in the fine paint, to make the whole picture more flat, more flavor, you need patience, patience, patience! Light a picture is so difficult and spend so long to retouch, 20 repair can be imagined. And a group of photos from the pre-conceptualization, to the difficult shooting and then to the final fine retouching, are poured into the photographer's time and effort, it can be said that the finished product after the blood, I hope that you see the beautiful photos at the same time, but also to understand the hardship.