How to make lantern balls by hand

1. First of all, the tools you need to prepare are: colored paper, a knife, pliers and some wire, and of course, an awl or a needle, which will be used to drill holes.

2. Colored paper needs two different colors, and the size is 4 copies of 7 inches by 9 inches. The unit here is inches. You can change it as needed.

3. Then draw three lines on the back of the colored paper. The center line is the center line, and the distance between the west line on both sides and the narrow side is 4 copies 1 inch.

4, and then start to cut small pieces of paper, the width of the paper is also 4 pieces 1 inch, so that you can just cut seven pieces, and finally you should always cut 14 pieces.

5. Punch holes in the middle of the three lines of each small piece of paper with a small awl or needle.

6. Then cut a 6-inch-long line and pull out a ring at one end of the line.

7. Then the note passes through the wire, and the colors of the note should be staggered.

8. This is the detail!

9. Then the next job starts from the bottom.

10, then turn one end up and pass through the top of the wire.

1 1. Then, you can pass the notes one by one. Be sure to start with the note at the bottom.

12, half of which is shown in the figure. Then complete the operation of the other half in the same way.

13. Then, when it is finished, tie the iron wire on it into a small ring for hanging at the back.