Traditional Culture Encyclopedia - Traditional culture - What are the precautions for the use of sea rods

What are the precautions for the use of sea rods

Abstract: The sea rod is also called casting rod or casting rod, which has a winding reel in the shank of the rod, which is wrapped with fishing line, so that when casting with force, the bait hooks can be thrown to the distant waters, and the distance thrown is very far. The sea rod on the market is imported from abroad, because it has many advantages, so it is quickly popularized in China, and has become the necessary fishing tackle for many anglers. What are the steps for using a sea rod? What are the precautions for the use of sea rods? What are the steps for using a sea rodWhat are the precautions for using a sea rod

What are the steps for using a sea rod

(1) Pull open the sea rod section by section, so that the overcoils are aligned and in a straight line, and the joints of each section should be pulled tight with a little force. The overcoils should be aligned with the winding reel catch.

(2) Install the reel, install the reel on the chuck, use the nut to fix it,

Turn the reel backstop switch to the reverse position, pull the line, the fishing line can be pulled out, and then through the coils one by one, until it passes through the tip of the rod over the coil. Then use the connecting loop to hang the attachments and bomb bait for casting.

(3) It's important to adjust the trolling mechanism by flipping the backstop switch back to the positive position. Too tight, too much resistance out of the line, easy to break the line when encountering big fish; too loose, too little resistance out of the line, too fast out of the line when encountering big fish, later than the end of the line to break the line. Generally, you should be able to pull the fishing line by hand.

(4) Rotate the reel so that the bait is 30-40 centimeters away from the rod tip. Then hold the rod in your right hand at the reel, clip the middle finger and ring finger to the back of the reel connection, hook the fishing line in the first joint of the index finger, flip the line ring, and cast the bait hook to the fishing spot in the way you are familiar with casting.

(5) to be attached to the water, immediately dial back the line ring and then crank the winding wheel handle to collect the line, when the line to retrieve part of the line, the line is still in a state of slack, put the rod on the bracket, the rod's angle of elevation (the rod and the ground into the) should be larger, that is, it should be steeper, the size of the angle of elevation and the rod tip response sensitivity has a direct relationship. Generally speaking, the greater the angle of elevation, the higher the sensitivity; on the contrary, the more sluggish. Another criterion for determining whether the angle of elevation is appropriate is the angle between the rod and the fishing line, when the angle is closer to 90 °, the more sensitive the response. Therefore, this angle is the core of reaction sensitivity. Once the rod is in place, a small bell is placed on the tip of the rod.

(6) In case of windy weather, the large angle of elevation will make the rod susceptible to the influence of the wind and swing. In order to make the rod to enhance the ability to resist the wind, you can reduce the angle of elevation, but not too small, that will make the tip of the rod sensitivity is reduced; in addition, you can also retrieve a few sections of the rod, so that the height of the rod to reduce the impact of the wind; or will be lying on the side of the rod on the shore, but pay attention to make the rod and the angle of the line between the rod, so that it is close to 90 °

(7) after the support of the rod, you can watch the reaction, or listen to the bell, or look at the tip of the rod. When you see the tip of the rod swinging sharply or ringing loudly, but can be reversed to hold the rod back to vigorously raise the rod, and then quickly reel in the line, after collecting a few meters of line, and then to raise the rod once, and so on several times, in order to make the hook firmly fish lips.

(8) After 20 to 30 minutes of bait entering the water, there is still no reaction, then you should get up and change the bait again. Because the bait will be dispersed soon after entering the water, after half an hour, the bait will be eaten up by small fish, and it will be a waste of time if you don't change the bait.

What are the precautions for the use of sea rods

1, do not forget to open the line gear when casting. The negative consequences of casting without opening the line gear are obvious. Some of the bomb hooks into the "heavenly flower", some because of too much force and break the line hurt rod [3].

2, the line should not be left too long. Dropped line refers to the line from the tip of the rod over the line ring counting down to the bomb hook to the distance of the line. The line is usually about 30 centimeters long, the line is too long will seriously constrain the casting action of the rod, the angler hair power blocked, have the strength to not make on, cast not far, and easy to hang in the back of the head of the ground on the twigs and weeds and things like that. Therefore, even in the case of tandem hooks, bomb hooks at the same time and use, dropping line should not exceed 40 centimeters.

3, fishing reel traction should not be screwed too tight. Screwed too tight should be appropriate to loosen a little, the wheel can rotate freely and out of the line on it. Fishing reel trolling too tight, big fish hooked when the rod will be pulled down the risk.

4, people and fish do not meet too early also do not copy fish too early. Prematurely pull the big fish close to the shore and exposed to the water, the fish will struggle desperately, at this time the struggle will be much greater than when hooked. The correct approach should be to put the line back and forth, repeatedly walking the fish, until the fish belly white into the net. But be careful not to walk the fish in waters with obstacles.

5, choose the fishing position should try to avoid the water in front of the left and right sides of the weeds, peanuts, tree branches and other things, because these obstacles will affect your walking fish.

6, copying the fish from the top to the bottom of the buckle, because the mouth of the fish still have hooks and line, from the top to the bottom of the copy, in any case, can not copy the fish. The correct approach should be to hold the rod in the left hand, the right hand holding the net, with the left hand walking the fish towards the right hand in time to sink the net in the big fish below. When the left hand walks the big fish to the mouth of the net and sinks the head a little, then the right hand holding the net quickly lifts the coping, the big fish will be copied into the net.

How to maintain the rods

1, if there is a bottom handle back cover of the rods, open the back cover, pull out all the rods, don't pull too tight, some slack is good. Put it in a ventilated place to dry or sun dry.

2, without the back cover of the rod, each section pull out three-quarters, placed in a ventilated place to dry or sun-drying, so that the water from the gap between the two sections evaporate out, the time should be longer, in order to dry.

3, if it is cloudy and rainy weather, the air humidity is very large, is not conducive to water evaporation. Can pull out half of each section of the sea rod, flat on the electric mattress heating, so that the water evaporation, can also be heated by the hairdryer dry.

4, when the sea rod fell in the sea, but also in a timely manner with water to wash fully, and then dry, because seawater on the rod more corrosive. The wheel should also open the side cover and wash it with water, because seawater is more corrosive to metal.