How to fix the door cover on the wall? Detailed description of door cover installation steps

Door covers are also door frames. Its function is to fix the door leaf, protect the corner and prevent the door from being scratched and damaged, which shows its importance. So, how can the door cover be fixed on the wall? Below I will introduce the door cover fixing technology in detail, hoping to help you.

How to fix the door cover on the wall Step 1: Basic frame

Choose strong wood as the core material, and cut the plate into equal width and small size according to the size of the original door cover to make the basic frame of the door frame. First determine the location, mark the horizontal line on the wall with an infrared level, then measure the size of the door, and play the vertical line with Mo Dou on both sides.

Step 2: Punch holes in the wall.

Punch a hole in the wall with an inflatable drill, and then add a wooden wedge. Remember to mark it at this time. At this time, the door cover should be installed vertically and horizontally in all directions to ensure the right angle of the door frame is straight, and then the nail should be inserted through the door frame and nailed into the wedge to fix the door frame on the wall.

Step 3: cascade one stage.

After the basic frame of the door cover is fixed, it can be overlapped. The purpose of this is to make it easier to open and close the door in the future, and the distance is about 4-5CM.

Step 4: Paste the panel.

How is the door cover fixed on the wall? After the installation of the above steps is completed, it is necessary to paste the panels (first check whether the panels of the same door are similar in color difference and whether there are burrs on the edges). Measure the size first, then cut the panel, and the gap at the junction is tight.

Step 5: Install the wooden line.

When the panel is finished, you can start to install the wooden line. Leave a distance of 1CM from the inside out, mark it, and then install the cut wood line according to the mark, which will make the whole door cover more beautiful. At this time, we must pay attention to leaving a space of about 5CM between the door frame and the ground to ensure that other processes can be carried out normally, such as leveling the ground, sticking the floor or tiles, and there can be enough space.

Step 6: Door blocking line

Nail the door blocking line on the door cover line with a nail gun, and then fix the door blocking line and the static bar. Just press the joint of the front and rear door frame lines and pay attention to the nails. Don't nail it all at once, because it may lead to the skew of the door frame and saw off the excess cork.

Step 7: Clean the surface.

After the door cover is installed, finally clean the surface of the wooden door cover.

Conclusion: Is it clear how to fix the door cover on the wall? According to the above steps, the installation of the wooden door cover is actually relatively simple. Need to remind friends that the size of the doorway must be measured in advance. If the size is wrong, it is likely that the wooden door cover and door opening are not embedded properly.